Need extra hardware? Order here!

These are stainless steel standard 3/8" x 16 thread socket head cap screws (we call them bolts) that you see in climbing gyms. Tighten them with a standard 5/16 hex (allen head) t-wrench or impact bit.

These work with standard climbing wall t-nuts. 

Great for outdoor use and use in wet environments. If you have an indoor wall check out Standard Alloy Bolts.

Select your sizes and quantity from the dropdown for pricing.

Thread: 1.5" bolts are fully threaded. 2" and up will have an unthreaded neck between the threads and cap head. These neck sizes vary by bolt length. Contact us if you have questions on a specific size.

Need help chosing your sizes? email us at holds@kiltergrips.com

Other Styles of Bolt: If your holds are tiny footholds with the washer close to the surface you'll need Buttonhead Bolts, or if they have no washer and instead have a countersunk attachment point (looks like a martini glass would fit in it) then the bolts have a flat top and are called Martini Bolts / Flatheads and we have those as well. 

Standard vs Metric: Standard 3/8" bolts are what we use in the US, Metric M10 bolts and t-nuts are used in the UK and Europe. M10 is slightly larger than 3/8". 3/8" bolts will actually work in M10 t-nuts, but because the Standard 3/8" bolt shaft is a little smaller than a Metric M10 bolt shaft, a Standard bolt in a Metric t-nut is a bit more likely to strip out the threads. Metric M10 bolts DO NOT fit in Standard T-Nuts, or sometimes you can get them in but they'll usually get stuck. It's always recommended to make sure you have the correct hardware that fits together correctly.